Juniper SRX 210 Services Hardware Manual page 144

SRX 210 Services Gateway Hardware Guide
2008-06-05 09:27:11 PDT
2008-06-05 09:27:11 PDT
regress@jaky> show chassis fpc
regress@jaky> show chassis fpc
Slot State
For more information on the
Administration Guide.
Table 35 on page 124 describes alarms that can occur for an SRX 210 services gateway
chassis component.
Table 35: SRX 210 Services Gateway Chassis Alarm Conditions and Corrective Actions
Component Alarm Conditions
Boot media The services gateway
boots from an alternate
boot device.
Mini-Physical A Mini-PIM has failed.
Interface
Module
(Mini-PIM)
124
Chassis and Interface Alarm Messages on the SRX 210 Services Gateway
Major
Major
Temp
(C)
0 Online -------------------- CPU less FPC --------------------
1 Online -------------------- CPU less FPC --------------------
Action
If the internal flash fails at startup, the services gateway
automatically boots itself from the alternative boot device (USB
storage device).
If you configured your services gateway to boot from an alternative
boot device, ignore this alarm condition.
If you did not configure the services gateway to boot from an
alternative boot device, contact JTAC. See "Juniper Networks
Technical Assistance Center" on page 128.
Contact JTAC. See "Juniper Networks Technical Assistance
Center" on page 128.
If you must replace the failed Mini-PIM, see the following topics
for replacing Mini-Pims:
Removing a Blank Mini-Physical Interface Module Faceplate
from the SRX 210 Services Gateway on page 116
Installing a Mini-Physical Interface Module in the SRX 210
Services Gateway on page 118
fe-0/0/4: Link down
fe-0/0/3: Link down
CPU Utilization (%) Memory
Total Interrupt DRAM (MB) Heap
show chassis alarms command, see the JUNOS Software
Utilization (%)
Buffer
Alarm
Severity
Yellow
(minor)
Red (major)