Juniper SRX 210 Services Hardware Manual page 107

Chapter 10: Establishing Basic Connectivity for the SRX 210 Services Gateway
Figure 15: Connecting to the Ethernet Port on an SRX 210 Services Gateway
From the management device you use to access the J-Web interface (such as a
1.
PC or a laptop), verify that the address of the port you connect to is set to one
of the following values:
Ethernet address on the
Ethernet address from a DHCP server
Turn off the power to the management device.
2.
Plug one end of the Ethernet cable (Figure 16 on page 88 shows the connector)
3.
into the Ethernet port on the management device.
Connect the other end of the Ethernet cable to the built-in Ethernet port on the
4.
services gateway.
Power on the services gateway by pressing the power button on the front panel.
5.
Wait until the
6. Status
Turn on the power to the management device. The services gateway assigns an
7.
IP address to the management device within the
if the services gateway is configured to use DHCP.
From the management device, open a Web browser and enter the IP address
8.
in the address field. The J-Web Quick Configuration Set Up page
192.168.1.1
appears.
Configure basic settings for your services gateway.
9.
Connecting an SRX 210 Services Gateway to the J-Web Interface
subnetwork other than
192.168.1/24
LED on the front panel turns solid green.
192.168.1.1
192.168.1.0/24 subnetwork
87