Juniper SRX 210 Services Hardware Manual page 115

Table 28: Quick Configuration Set Up Summary (continued)
Field Function
NTP Servers Specifies an NTP server that the services
gateway can reach to synchronize the system
time.
Current System Time Synchronizes the system time with the NTP
server or allows you to manually set the system
time and date.
Network
DNS Name Servers Specifies a DNS server that the services
gateway can use to resolve hostnames into
addresses.
Domain Search Adds each domain name that includes the
services gateway to the configuration so that
each domain is included in a DNS search.
Default Gateway Defines a default gateway through which to
direct packets addressed to networks not
explicitly listed in the routing table.
Loopback Address Defines a reserved IP address that is always
available on the services gateway. If no address
is entered, this address is set to
Management Access
Allow Telnet Access Allows remote access to the services gateway
using Telnet.
Allow JUNOScript Allows JUNOScript to access the services
over Clear-Text gateway using a protocol for sending
Access unencrypted text over a TCP connection.
Allow SSH Access Allows remote access to the services gateway
using SSH.
Related Topics
Configuring Basic Settings for the SRX 210 Services Gateway with J-Web Quick Configuration
Chapter 10: Establishing Basic Connectivity for the SRX 210 Services Gateway
127.0.0.1/32
SRX 210 Services Gateway Basic Connectivity Overview on page 78
Connecting an SRX 210 Services Gateway to the J-Web Interface on page 86
Your Action
To add an IP address, type it in the box to the left
of the Add button, then click Add.
To delete an IP address, click on it in the box above
the Add button, then click Delete.
To immediately set the time using the NTP
server, click Set Time via NTP. The services
gateway sends a request to the NTP server and
synchronizes the system time.
NOTE: If you are configuring other settings on this
page, the services gateway also synchronizes the
system time using the NTP server when you click
Apply or OK.
To set the time manually, click Set Time
Manually. A window allows you to select the
current date and time from lists.
To add an IP address, type it in the box to the left
of the Add button, then click Add.
To delete an IP address, click on it in the box above
the Add button, then click Delete.
To add a domain name, type it in the box to the left
of the Add button, then click Add.
To delete a domain name, click on it in the box
above the Add button, then click Delete.
Type a 32-bit IP address in dotted decimal notation.
Type a 32-bit IP address and prefix length in dotted
decimal notation.
.
To enable Telnet access, select the box.
To enable JUNOScript access over cleartext, select
the box.
To enable SSH access, select the box.
95