Juniper SRX 210 Services Hardware Manual page 112

SRX 210 Services Gateway Hardware Guide
8.
9.
NOTE: Most modems have an RS-232 DB-25 connector. You must separately purchase
an adapter to connect your modem to the RJ-45 to DB-9 adapter and Ethernet cable
supplied with the services gateway.
Figure 18: Console Cable Connector
Related Topics
Connecting to the CLI at the User End for the SRX 210 Services Gateway
To remotely connect to the CLI through a dial-up modem connected to the console
port on the SRX 210 services gateway:
1.
2.
3.
4.
Table 27: Port Settings
Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
5.
92
Connecting to the CLI at the User End for the SRX 210 Services Gateway
Turn on the power to the modem.
Power on the services gateway by pressing the power button on the front panel.
Verify that the LED on the front panel turns green.
Power
Connecting the Modem at the SRX 210 Services Gateway End on page 90
Connecting to the CLI at the User End for the SRX 210 Services
Gateway on page 92
Connecting an SRX 210 Services Gateway to the CLI Remotely on page 90
Connect a modem at your remote location to a management device such as a
PC or laptop computer.
Start your asynchronous terminal emulation application (such as Microsoft
Windows HyperTerminal) on the PC or laptop computer.
Select the COM port to which the modem is connected (for example,
Configure the port settings shown in Table 25 on page 92.
In the HyperTerminal window, enter
Value
9600
8
None
1
None
.
AT
COM1 ).