Configuring Secure Access To The J-Web Interface For The Srx 210 Services Gateway - Juniper SRX 210 Services Hardware Manual

Related Topics

Configuring Secure Access to the J-Web Interface for the SRX 210 Services Gateway

Navigate to the Secure Access Quick Configuration page by selecting
Configuration>Quick Configuration>Secure Access. On this page, you can enable
HTTP and HTTPS access on interfaces for managing SRX 210 services gateways
through the Web interface. You can also install SSL certificates and enable JUNOScript
over SSL with the Secure Access page.
Figure 20 on page 105 shows the Secure Access Quick Configuration page.
Figure 20: Secure Access Quick Configuration Page
To configure Web access settings in the J-Web interface:
1.
2.
Chapter 11: Configuring Secure Web Access for the SRX 210 Services Gateway
SRX 210 Services Gateway Basic Connectivity Overview on page 78
Configuring Secure Access to the J-Web Interface for the SRX 210 Services
Gateway on page 105
Enter information into the Secure Access Quick Configuration page, as described
in Table 32 on page 106.
Click one of the following buttons:
To apply the configuration and stay on the Secure Access Quick Configuration
page, click Apply.
Configuring Secure Access to the J-Web Interface for the SRX 210 Services Gateway
105