Juniper SRX 210 Services Hardware Manual page 86

SRX 210 Services Gateway Hardware Guide
Removing and Installing Mini-Physical Interface Modules in the SRX 210 Services
Gateway
Mini-Physical Interface Modules (Mini-PIMs) are circuit boards that you install in a
device. They enable you to easily add or change physical interfaces on a device.
The Mini-Physical Interface Module (Mini-PIM) slots are covered with a blank faceplate
to maintain proper airflow through the services gateway. Before installing the
Mini-PIM, you have to remove the faceplate.
See the following topics for installing the Mini-PIMs:
Related Topics
66
Removing and Installing Mini-Physical Interface Modules in the SRX 210 Services Gateway
Removing a Blank Mini-Physical Interface Module Faceplate from the SRX 210
Services Gateway on page 116
Installing a Mini-Physical Interface Module in the SRX 210 Services
Gateway on page 118
Removing a Mini-Physical Interface Module from the SRX 210 Services
Gateway on page 117
Required Tools and Parts for Replacing a Mini-Physical Interface Module on the
SRX 210 Services Gateway on page 115
SRX 210 Services Gateway Installation Safety Guidelines and Warnings on page 138
SRX 210 Services Gateway Installation on page 60
Removing a Blank Mini-Physical Interface Module Faceplate from the SRX 210
Services Gateway on page 116
Installing a Mini-Physical Interface Module in the SRX 210 Services
Gateway on page 118
Removing a Mini-Physical Interface Module from the SRX 210 Services
Gateway on page 117