Juniper SRX 210 Services Hardware Manual page 32

SRX 210 Services Gateway Hardware Guide
Figure 1: SRX 210 Services Gateway
CAUTION: Before removing or installing components of a functioning services
gateway, attach an electrostatic discharge (ESD) strap to an ESD point and place the
other end of the strap around your bare wrist. Failure to use an ESD strap could result
in damage to the services gateway.
Related Topics
SRX 210 Services Gateway Front Panel
The front panel of the SRX 210 services gateway consists of the following components:
Figure 2 on page 13 shows the front panel of the SRX 210 services gateway.
12
SRX 210 Services Gateway Front Panel
SRX 210 Services Gateway Description on page 3
SRX 210 Services Gateway Front Panel on page 12
SRX 210 Services Gateway Back Panel on page 19
Monitoring the SRX 210 Services Gateway Components using LEDs on page 122
SRX 210 Services Gateway Electrical Safety Guidelines and Warnings on page 150
Fast Ethernet ports
Gigabit Ethernet ports
Power button
Reset Config button
Console port
USB ports
Mini-Physical Interface Module (Mini-PIM) slot
Front panel LEDs