Juniper SRX 210 Services Hardware Manual page 82

SRX 210 Services Gateway Hardware Guide
Figure 9: Hanging an SRX 210 Services Gateway in a Rack
5.
6.
7.
Installing the SRX 210 Services Gateway on a Desk
You can install the SRX 210 services gateway on a desk, table, or other level surface.
The device is shipped with the rubber feet attached. The rubber feet are necessary
to stabilize the device on the desk. You can install the device in a horizontal or vertical
position. The horizontal position is the standard installation position and does not
require the vertical installation kit. The vertical position requires the vertical installation
kit, which consists of a vertical installation stand with the rubber feet attached.
To install the device in a vertical position:
1.
62
Installing the SRX 210 Services Gateway on a Desk
Have a second person install a mounting screw into each of the two aligned
holes. Use a number–2 phillips screwdriver to tighten the screws.
Install the second screw in each mounting bracket.
Verify that the mounting screws on one side of the rack are aligned with the
mounting screws on the opposite side and that the device is level.
Attach the vertical stand to the right side of the chassis using the specified screws
as shown in Figure 10 on page 63.