Removing A Mini-Physical Interface Module From The Srx 210 Services Gateway; Installing A Mini-Physical Interface Module In The Srx 210 Services - Juniper SRX 210 Services Hardware Manual

Figure 21: Removing a Blank Mini-PIM faceplate from the SRX 210 Services Gateway
Related Topics

Removing a Mini-Physical Interface Module from the SRX 210 Services Gateway

NOTE: The Mini-Physical Interface Modules (Mini-PIMs) available on the SRX 210
services gateway are not hot-swappable. You need to power off the device before
removing or installing Mini-PIMs.
To remove a Mini-PIM from an SRX 210 services gateway:
1.
2.
3.
4.
5.
6.
7.
Chapter 13: Replacing Mini-Physical Interface Modules on the SRX 210 Services Gateway
Required Tools and Parts for Replacing a Mini-Physical Interface Module on the
SRX 210 Services Gateway on page 115
Removing a Mini-Physical Interface Module from the SRX 210 Services
Gateway on page 117

Installing a Mini-Physical Interface Module in the SRX 210 Services

Gateway on page 118
Place an electrostatic bag or antistatic mat on a flat, stable surface on which you
intend to place the Mini-PIM.
Attach an ESD grounding strap to your bare wrist, and connect the strap to the
grounding point on the back of the device.
Unplug the power adapter from the device. Verify that the Power LED is off.
Label the cables connected to the Mini-PIM so that you can later reconnect each
cable to the correct Mini-PIM.
Disconnect the cables from the Mini-PIM.
If necessary, arrange the cables to prevent them from dislodging or developing
stress points.
Loosen and remove the screws on each side of the Mini-PIM faceplate using a
screwdriver.
Removing a Mini-Physical Interface Module from the SRX 210 Services Gateway
117