Srx 210 Services Gateway Interface Cable Specifications And; Interface Cable And Wire Specifications For The Srx 210 Services Gateway; Rj-45 Connector Pinouts For The Srx 210 Services Gateway Ethernet - Juniper SRX 210 Services Hardware Manual

Appendix D
SRX 210 Services Gateway Interface
Cable Specifications and Connector
Pinouts

Interface Cable and Wire Specifications for the SRX 210 Services Gateway

The network interfaces supported on the services gateway accept different kinds of
network cables.
This section includes the following topics:
Interface Cable and Wire Specifications for the SRX 210 Services
Gateway on page 161

RJ-45 Connector Pinouts for the SRX 210 Services Gateway Ethernet

Port on page 162
RJ-45 Connector Pinouts for the SRX 210 Services Gateway Console
Port on page 163
RJ-48 Connector Pinouts for the SRX 210 Services Gateway T1/E1 Mini-Physical
Interface Module on page 163
RJ-11 Connector Pinouts for the SRX 210 Services Gateway ADSL2 +
Mini-PIM on page 166
Table 40 on page 161 lists the specifications for the cables that connect to ports and
the wires that connect to the alarm relay contacts.
Table 40: Cable and Wire Specifications for Ports and Alarm Interfaces
Port Cable Specification
Console port RS-232 (EIA-232) serial
cable
Ethernet Category 5 cable or
port equivalent suitable for
100Base-T operation
Interface Cable and Wire Specifications for the SRX 210 Services Gateway
Cable/Wire Supplied Maximum
Length
One 6-ft (1.83-m) 6 ft
length with (1.83 m)
DB-9/DB-9 connectors
One 15-ft (4.57-m) 328 ft
length with (100 m)
RJ-45/RJ-45
connectors
Device
Receptacle
DB-9 male
RJ-45
autosensing
161