Srx 210 Services Gateway Back Panel - Juniper SRX 210 Services Hardware Manual

On the SRX 210 services gateway, each Ethernet port (Gigabit Ethernet port and Fast
Ethernet port) has two LEDs, a TX/RX/LINK LED on the left side and a PoE (Power
over Ethernet) LED on the right side of the chassis.
NOTE: The PoE LED is enabled only on the PoE variant of the SRX 210 services
gateway. For non-PoE gateways, the PoE LED remains off.
Table 7 on page 19 describes the built-in Ethernet port LEDs.
Table 7: SRX 210 Services Gateway Ethernet Port LEDs
Function
TX/RX/LINK
PoE Status
Related Topics

SRX 210 Services Gateway Back Panel

The back panel of the SRX 210 services gateway consists of the following components:
Figure 3 on page 20 illustrates the back panel of the SRX 210 services gateway.
Chapter 2: SRX 210 Services Gateway Hardware Components and Specifications
Color State
Green Blinking
Steady
Unlit Off
Green Steady
Yellow Steady
Unlit Off
SRX 210 Services Gateway Chassis on page 11
SRX 210 Services Gateway Back Panel on page 19
Monitoring the SRX 210 Services Gateway Components using LEDs on page 122
SRX 210 Services Gateway Boot Devices on page 20
ExpressCard slot
Grounding point
Power supply
Description
Link is up. Data communication is
taking place.
Link is up. No data communication is
taking place.
Link is down.
PoE (Power over Ethernet) is on and
the connected Power Device is
receiving power.
PoE (Power over Ethernet) is on, but
the connected Power Device is not
receiving power (fault or not enough
power).
PoE is off.
SRX 210 Services Gateway Back Panel
19