Juniper SRX 210 Services Hardware Manual page 146

SRX 210 Services Gateway Hardware Guide
Table 36: Services Gateway Power LED Status
LED Status
Green
Amber
Off
Related Topics
Resetting the Configuration File When the SRX 210 Services Gateway Is
Inaccessible
You can use the SRX 210 services gateway's Reset Config button to restore the
device's configuration file when the current one is faulty or fails. You can also change
the default behavior of the Reset Config button.
This section includes the following topics:
126
Resetting the Configuration File When the SRX 210 Services Gateway Is Inaccessible
Meaning
Device is receiving power, and the
internal power supply is functional.
Indicates that the Power button has
been pressed and quickly released.
The device is gracefully shutting
down.
Indicates that the device is not
receiving power.
CLI on the SRX 210 Services Gateway on page 121
Monitoring the SRX 210 Services Gateway Components using LEDs on page 122
Chassis and Interface Alarm Messages on the SRX 210 Services
Gateway on page 123
Using the Reset Config Button on the SRX 210 Services Gateway on page 127
Changing the Reset Config Button Behavior on the SRX 210 Services
Gateway on page 127
Juniper Networks Technical Assistance Center on page 128
Using the Reset Config Button on the SRX 210 Services Gateway on page 127
Changing the Reset Config Button Behavior on the SRX 210 Services
Gateway on page 127
Possible Cause and Corrective Action
Normal indication. No action is required.
Normal indication. No action is required.
Verify that the AC power cord from the power
source to the device are not damaged. If the
insulation is cracked or broken, immediately
replace the cord or cable.
Ensure that the socket you plug in is in
working condition.
Ensure the device has an AC input voltage
between 110 and 240 VAC.
If you cannot determine the cause of the
problem or need additional assistance, see
"Juniper Networks Technical Assistance
Center" on page 128.