Rj-45 Connector Pinouts For The Srx 210 Services Gateway Console Port - Juniper SRX 210 Services Hardware Manual

RJ-45 Connector Pinouts for the SRX 210 Services Gateway Console Port

The port on the front panel labeled CONSOLE is an autosensing 10/100-Mbps Ethernet
RJ-45 receptacle that accepts an RJ-45 cable for connecting the services gateway to
a management LAN (or other device that supports out-of-band management).
Table 42 on page 163 describes the RJ-45 connector pinouts for the console port.
Table 42: RJ-45 Connector Pinouts for Services Gateway Console Port
Pin
1
2
3
4
5
6
7
8
Related Topics
RJ-48 Connector Pinouts for the SRX 210 Services Gateway T1/E1 Mini-Physical
Interface Module
The T1/E1 Mini-PIM uses an RJ-48 cable, which is not supplied with the Mini-PIM.
Appendix D: SRX 210 Services Gateway Interface Cable Specifications and Connector Pinouts
RJ-48 Connector Pinouts for the SRX 210 Services Gateway T1/E1 Mini-Physical
Interface Module on page 163
RJ-11 Connector Pinouts for the SRX 210 Services Gateway ADSL2 +
Mini-PIM on page 166
Signal
RTS
DTR
TXD
Ground
Ground
RXD
DSR/DCD
CTS
Interface Cable and Wire Specifications for the SRX 210 Services
Gateway on page 161
RJ-45 Connector Pinouts for the SRX 210 Services Gateway Ethernet
Port on page 162
RJ-48 Connector Pinouts for the SRX 210 Services Gateway T1/E1 Mini-Physical
Interface Module on page 163
RJ-11 Connector Pinouts for the SRX 210 Services Gateway ADSL2 +
Mini-PIM on page 166
RJ-45 Connector Pinouts for the SRX 210 Services Gateway Console Port
Description
Request to Send
Data Terminal Ready
Transmit Data
Signal Ground
Signal Ground
Receive Data
Data Set Ready
Clear to Send
163