Preparing The Srx 210 Services Gateway For Rack-Mount Installation; Preparing The Srx 210 Services Gateway For Desk-Mount Installation; Preparing The Srx 210 Services Gateway For Wall-Mount Installation - Juniper SRX 210 Services Hardware Manual

SRX 210 Services Gateway Hardware Guide

Preparing the SRX 210 Services Gateway for Rack-Mount Installation

You can mount an SRX 210 services gateway on four-post (telco) racks, enclosed
cabinets, and open-frame racks. Center mount racks are not supported.
Before mounting the SRX 210 services gateway in a rack:
NOTE: The rack-mounting kit is not shipped with the device.
Related Topics

Preparing the SRX 210 Services Gateway for Desk-Mount Installation

You can mount an SRX 210 services gateway on a desk or other level surface
horizontally or vertically. The four rubber feet attached to the chassis provide stability.
56
Preparing the SRX 210 Services Gateway for Rack-Mount Installation
Verify that the site meets the requirements described in "Site Preparation
Checklist for the SRX 210 Services Gateway" on page 41.
Verify that the racks or cabinets meet the specific requirements described in
"SRX 210 Services Gateway Rack Requirements" on page 45.
Place the rack or cabinet in its permanent location, allowing adequate clearance
for airflow and maintenance, and secure it to the building structure. For more
information, see "Clearance Requirements for Airflow and Hardware Maintenance
of the SRX 210 Services Gateway" on page 46.
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see "Unpacking the SRX 210 Services Gateway" on page 51.
Verify that you have the following parts available in your rack-mounting kit for
the SRX 210 services gateway:
Rack-mounting brackets
Screws
Site Preparation Checklist for the SRX 210 Services Gateway on page 41
SRX 210 Services Gateway Rack Requirements on page 45
Clearance Requirements for Airflow and Hardware Maintenance of the SRX 210
Services Gateway on page 46
Unpacking the SRX 210 Services Gateway on page 51
Preparing the SRX 210 Services Gateway for Rack-Mount, Desk-Mount, and
Wall-Mount Installation on page 55
Preparing the SRX 210 Services Gateway for Desk-Mount Installation on page 56
Preparing the SRX 210 Services Gateway for Wall-Mount Installation on page 57