SRX550 Services Gateway Hardware Guide
RJ-45 Connector Pinouts for the SRX550 Services Gateway Ethernet Port
Related
Documentation
RJ-45 Connector Pinouts for the SRX550 Services Gateway Console Port
56
The port on the front panel labeled ETHERNET is an autosensing 10/100-Mbps Ethernet
RJ-45 receptacle that accepts an Ethernet cable for connecting the services gateway to
a management LAN (or other device that supports out-of-band management).
Table 20 on page 56
describes the RJ-45 connector pinouts for the Ethernet port.
Table 20: RJ-45 Connector Pinouts for Services Gateway Ethernet Port
Pin
1
2
3
4
5
6
7
8
RJ-45 Connector Pinouts for the SRX550 Services Gateway Console Port on page 56
Interface Cabling and Wiring Specifications for the SRX550 Services Gateway on
page 55
The port on the front panel labeled CONSOLE is an autosensing 10/100-Mbps Ethernet
RJ-45 receptacle that accepts an RJ-45 cable for connecting the services gateway to a
management LAN (or other device that supports out-of-band management).
Table 21 on page 56
describes the RJ-45 connector pinouts for the console port.
Table 21: RJ-45 Connector Pinouts for the Services Gateway Console Port
Pin
1
2
3
Signal
TX+
TX-
RX+
Termination network
Termination network
RX-
Termination network
Termination network
Signal
RTS
DTR
TXD
Copyright © 2015, Juniper Networks, Inc.
Description
Request to Send
Data Terminal Ready
Transmit Data