Delete Ports; Show Ports - D-Link DGS-1100-06/ME Cli Reference Manual

Restrictions
Example usage:
To configure the speed of ports 1-3 to be 100 Mbps, full duplex, learning and state enabled:
DGS-1100-06/ME:5#config ports 1-3 medium_type copper speed 100_full learning
enable state enable
Command: config ports 1-3 medium_type copper speed 100_full learning enable
state enable
Success
DGS-1100-06/ME:5#

delete ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the description of port 3 on the Switch:
DGS-1100-06/ME:5# delete ports 3 medium_type copper description
Command: delete ports 3 medium_type copper description
DGS-1100-06/ME:5#

show ports

Purpose
Syntax
Description
Parameters
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide

auto − Enables auto-negotiation for the specified range of
ports.

[10 | 100 | 1000] − Configures the speed in Mbps for the
specified range of ports.

[half | full] − Configures the specified range of ports as either
full or half-duplex.
Only administrator or operate-level users can issue this command.
To delete the description of current configuration port.
delete ports [<portlist> | all] medium_type [copper | fiber_100 |
fiber_1G] description
The delete ports command deletes the description of current
configuration port or range of ports.
[<portlist> | all] − All port or range of ports whose settings are to be
removed.
medium_type [copper | fiber_100 | fiber_1G] − If configuring the
Combo ports, this description the type of medium being removed.
Only administrator or operate-level users can issue this command.
To display the current configuration of a range of ports.
show ports {<portlist> | all} {description | err_disabled}
The show ports command displays the current configuration of a
port or range of ports.
<portlist> − A port or range of ports whose settings are to be
displayed.
all – Specifies all ports to be displayed.
31