Show Ports - D-Link DGS-3200 SERIES Cli Manual

flow_control
learning
state
description
Note: Gigabit Ethernet ports are statically set to 1 Gbps and their speed cannot be modified.
Restrictions
You must have administrator privileges.
Example
To configure the speed of ports 1 to 3 of unit 1 to be 10 Mbps, with full duplex, learning enabled, state
enabled, and flow control enabled:
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g p o r t s 1 - 3 s p e e d 1 0 _ f u l l s t a t e e n a b l e l e a r n i n g e n a b l e
f l o w _ c o n t r o l e n a b l e
C o m m a n d : c o n f i g p o r t s 1 - 3 s p e e d 1 0 _ f u l l s t a t e e n a b l e l e a r n i n g e n a b l e f l o w _ c o n t r o l
e n a b l e
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

2-2 show ports

Purpose
Used to display the current configurations of a range of ports.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
1000_full
You can turn on or turn off flow control on one or more ports by setting
flow_control to enable or disable.
You can turn on or turn off MAC address learning on one or more
ports.
Enables or disables the specified port.
If the specified ports are in error-disabled status, configuring their state
to enable will recover these ports from disabled to enable state.
Describes the port interface.
1000_full sets port speed to 1000_full. When setting
port speed to 1000_full, user should specify master or
slave mode for 1000 base TX interface, and leave the
1000_full without any master or slave setting for other
interface.
25