Show Dscp Map - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator, Operator level users can issue this command.
Example
In the case of a product supporting per-port DSCP mapping configuration, to configure the
mapping of DSCP priority 1 to priority 1:
DGS-3620-28SC:admin#config dscp map 1:1-1:8 dscp_priority 1 to priority 1
Command: config dscp map 1:1-1:8 dscp_priority 1 to priority 1
Success.
DGS-3620-28SC:admin#
In the case of a product supporting global DSCP mapping configuration, to configure the global
mapping of DSCP priority 1 to priority 1:
DGS-3620-28SC:admin#config dscp map dscp_priority 1 to priority 1
Command: config dscp map dscp_priority 1 to priority 1
Success.
DGS-3620-28SC:admin#

85-19 show dscp map

Description
This command is used to display the DSCP map configuration parameters.
Format
show dscp map { <portlist> } [dscp_priority | dscp_dscp] {dscp <dscp_list>}
Parameters
<portlist> - The range of ports to display. If no parameter is specified, the DSCP mapping for all
ports will be displayed. If the project only support global configuration, the global information
will be displayed.
dscp_priority - Specifies the list of DSCP values to be mapped to a specific priority.
dscp_dscp - Specifies the list of DSCP values to be mapped to a specific DSCP.
dscp - This specifies the DSCP value that will be mapped.
<dscp_list> - Enter the dscp list number here.
Restrictions
Only Administrator and Operator level users can issue this command.
991