Vlan Configuration Examples - Avaya G250 Administration

Configuring advanced switching
Use the set port static-vlan command to assign static VLANs to ports.
●
Use the set port vlan command to set the port VLAN ID (PVID).
●
Use the set port vlan-binding-mode command to define the binding method used
●
by ports.
Use the set trunk command to configure the VLAN tagging mode of a port.
●
Use the set vlan command to configure VLANs.
●
Use the show cam vlan command to display all mac entries in the CAM table for a
●
specific vlan.
Use the show interfaces vlan command to display interface configuration and
●
statistics for a particular VLAN or all VLANs.
Use the show port-vlan-binding command to display port VLAN binding mode
●
information. If no module number is specified then information for all ports on all modules
is displayed. If no port number is specified, information for all ports on the specified module
is displayed.
Use the show trunk command to display VLAN tagging information for the switch.
●
Use the show vlan command to display the VLANs configured in the switch.
●

VLAN configuration examples

This section provides VLAN configuration examples.
The following example deletes a statically bound VLAN from a port:
G350-001(super)# clear port static-vlan 10/3 34
VLAN 34 is unbound from port 10/3
The following example deletes a VLAN and its interface:
G350-001(super)# clear vlan 34
This command will assign all ports on VLAN 34 to their default in
the entire management domain — do you want to continue (Y/N)? y
All ports on VLAN-id assigned to default VLAN.
VLAN 34 was deleted successfully.
The following example sets the current VLAN as the ICC-VLAN:
G350-001(super)# interface Vlan 66
G350-001(super-if:Vlan 66)# icc-vlan
Done!
224 Administration for the Avaya G250 and Avaya G350 Media Gateways