Default Actions; Deleting A Policy List; Attaching Policy Lists To An Interface - Avaya G250 Administration

Default actions

When no rule matches a packet, the G250/G350 applies the default action for the list. The
following table shows the default action for each type of policy list:

Deleting a policy list

To delete an access control list, type no ip access-control-list, followed by the number
of the list you want to delete. To delete a QoS list, type no ip qos-list, followed by the
number of the list you want to delete.

Attaching policy lists to an interface

The following policy lists are attached to each interface on the Avaya G250/G350 Media
Gateway:
Ingress Access Control List
●
Ingress QoS List
●
Egress Access Control List
●
Egress QoS List
●
Note:
You can also attach PBR lists to certain interfaces, but PBR lists are not attached
Note:
to any interface by default.
When a packet enters the G250/G350 through an interface, the G250/G350 applies the policy
lists in the following order:
1. Apply the Ingress Access Control List.
If the Ingress Access Control List does not drop the packet:
2. Apply the Ingress QoS List.
3. Apply the PBR list (if any).
4. The packet enters the G250/G350 through the interface.
List Default action
Access control list Accept all packets
QoS list No change to the priority or DSCP
Attaching policy lists to an interface
Issue 1.1 June 2005 447