Configuring Rtcp Qos Parameters; Configuring Rsvp Parameters - Avaya G250 Administration

Use the voip-queue-delay command to set the maximum queue delay for which to
●
estimate the high priority queue size necessary to meet the queuing delay for a specific
VoIP codec. To determine the queue size you currently have, use the show queueing
command.
Use the show qos command to display the local and downloaded QoS parameters.
●

Configuring RTCP QoS parameters

Use the following commands to configure QoS monitoring for RTCP:
Use the set qos rtcp command to permit the setup of RTCP parameters. The
●
parameters that can be set are enabling or disabling RTCP reporting capability, setting the
IP address of the monitor, setting the reporting period (the default is 5 sec.), and defining
the listening port number.
Use the show qos-rtcp command to display QoS, RSVP, and RTCP parameters.
●

Configuring RSVP parameters

VoIP uses the RSVP protocol to reserve network resources for voice data while communicating
with other media gateways and other VoIP entities, such as IP phones and Softphones.
Use the set qos rsvp command to set the current values for the RSVP parameters of
●
the VoIP engines. The parameters that can be set are enabled/disabled, refresh rate
(seconds), failure retry (y or n), and service profile (Guaranteed or Controlled).
Use the show qos-rtcp command to display QoS, RSVP, and RTCP parameters.
●
Configuring RTCP QoS parameters
Issue 1.1 June 2005 123