Configuring The Avaya Mm342 Usp Wan Media Module - Avaya G250 Administration

Configuring the Avaya MM342 USP WAN media module

For a list of the USP default settings, see
To configure USP ports:
1. Use the interface Serial command to enter the context of the interface. Specify the
slot number of the media module, the port number, and optionally the IP interface number.
Note:
The WAN media module in a G250 must always be in slot number 2.
Note:
If you do not specify an IP interface number for the first serial interface that you define on a
port, the G250/G350 automatically assigns IP interface number 0. For each additional serial
interface that you define on the port, use a different IP interface number. For example:
- interface Serial 2/1 enters a serial interface on the media module in slot number
2, on port number 1.
- interface Serial 5/1.2 enters a serial interface on the media module in slot
number 5, on port number 1, with IP interface number 2.
The prompt changes to:
G350-001(super-if:Serial s/p)#
For example:
G350-001(super-if:Serial 2/1)#
2. Use the following commands to change the idle characters, transmitter delay, encoding
type, bandwidth parameters, line monitoring, and from their default settings:
- idle characters flags|marks sets the bit pattern used to indicate an idle line.
Use the no form of this command to restore the default value (flags).
- transmitter-delay number sets the minimum number of flags to be sent between
successive packets. Use the no form of the command to restore the transmitter-delay
value to the default (0).
Note:
The transmitter-delay command is usually used when the DCE equipment
Note:
that is connected directly to the G250/G350, or the router on the WAN have a
receive buffer that is not large enough to hold the traffic sent by the G250/G350.
In this case, configure transmitter-delay on the DCE equipment or the
remote router in order to preserve the high performance that you had when
transmitter-delay was configured to 0 on the G250/G350.
- nrzi-encoding enables the non-return-to-zero inverted (NRZI) line coding format on
the specified interface. Use the no form of the command to disable NRZI encoding.
USP default settings on page 138.
Initial WAN configuration
Issue 1.1 June 2005 137