Avaya G250 Administration page 75
Media gateway
Hide thumbs
Also See for G250:
- Administration manual (840 pages) ,
- Reference (812 pages) ,
- Administration (720 pages)
Table of Contents
Advertisement
Use the copy tftp SW_imageA command to upgrade the G250/G350 firmware into
●
Bank A from a TFTP server.
Use the copy tftp SW_imageB command to upgrade the G250/G350 firmware into
●
Bank B from a TFTP server.
Use the copy ftp EW_archive command to upgrade the Java applet for Avaya G350
●
Manager software from an FTP server.
Note:
This command is not supported on the G250.
Note:
Use the copy ftp module command, followed by the module number of the module you
●
want to upgrade, to upgrade the firmware on a media module from an FTP server.
Use the copy ftp SW_imageA command to upgrade the G250/G350 firmware into Bank
●
A from an FTP server.
Use the copy ftp SW_imageB command to upgrade the G250/G350 firmware into Bank
●
B from an FTP server.
Use the copy tftp EW_archive command to upgrade the Java applet for Avaya G350
●
Manager software from a TFTP server.
Note:
This command is not supported on the G250.
Note:
Use the copy tftp module command, followed by the module number of the module
●
you want to upgrade, to upgrade the firmware on a media module from a TFTP server.
Use the copy tftp SW_imageA command to upgrade the G250/G350 firmware into
●
Bank A from a TFTP server.
Use the copy tftp SW_imageB command to upgrade the G250/G350 firmware into
●
Bank B from a TFTP server.
When using FTP or TFTP commands, you must use the specific path to the file on the FTP or
TFTP server according to the home directory of the service (FTP or TFTP) that you are using.
For example, to upgrade the firmware of an MM340 media module in slot 2 from a TFTP server
with the IP address 192.1.1.10, where the home directory is c:\home\ftp\ and the upgrade file is
located in the directory c:\home\ftp\version, use the following command:
copy tftp module \version\mm340v51.fdl 192.1.1.10 2
Note:
When uploading firmware from the S8300, use only the file name, without the
Note:
directory path, in the command line. Otherwise, the procedure will fail. For
instance, in the example above, you must use the following command:
copy tftp module mm340v51.fdl 192.1.1.10 2
Note:
When uploading firmware from the S8300 using TFTP, you may need to enable
Note:
TFTP service in the Set LAN Security parameters of your web server.
Version management
Issue 1.1 June 2005
75
Advertisement
Table of Contents
