Usp Default Settings - Avaya G250 Administration

Configuring WAN interfaces
- bandwidth kbps sets the bandwidth parameter manually for the interface. Use the no
form of this command to restore the bandwidth parameter to its default value (2,048). The
manually specified bandwidth value overrides the dynamically calculated bandwidth
during route cost calculations.
Note:
If you are using the USP port as a clock source, configure the port's bandwidth to
Note:
match the DCE clock rate.
- ignore dcd specifies how the system monitors the line to determine if it is up or down.
Specify ignore dcd to ignore DCD signals, and instead use DSR/CTS signals to
determine the line's status. Use the no form of the command to specify that DCD signals
are used to determine line status.
- invert txclock inverts the transmit clock signal from the data communications
equipment (DCE). Use the no form of the command to restore the signal to not inverted.
3. Configure the interface encapsulation:
- For PPP encapsulation, see
- For frame relay encapsulation, see
4. Type exit to return to general context. The prompt returns to:
G350-001(super)#
5. Repeat Step 1 to configure additional serial interfaces on the USP port.
6. Test the WAN configuration. See
connectivity
7. Use the copy running-config startup-config command to save the configuration.

USP default settings

Table 7 shows the default settings for USP WAN lines on the G250/G350:
Table 7: USP default settings
Function
Encoding
Bandwidth
Line-up indicator signal
138 Administration for the Avaya G250 and Avaya G350 Media Gateways
Configuring PPP
Verifying the WAN configuration and testing
on page 145.
on page 139.
Configuring frame relay
Default setting
NRZ
2048 kbps
DCD
on page 143.