Configuring IPSec VPN
Configuring a site-to-site IPSec VPN
This section describes the procedures for VPN configuration, including:
Installing the VPN license file
●
Configuring IPSec VPN
●
IPSec VPN maintenance
●
Installing the VPN license file
To enable IPSec VPN you must obtain and install a VPN license. For information on obtaining a
VPN license, see Installation and Upgrades for the Avaya G250 Media Gateway, 03-300434 or
Installation and Upgrades for the Avaya G350 Media Gateway, 03-300394.
You can install the VPN license via any of the following:
FTP
●
TFTP
●
SCP
●
Note:
You must have admin permissions to install a VPN license.
Note:
To install the license file:
1. Use one of the following commands:
copy ftp license-file filename ip
●
●
copy tftp license-file filename ip
●
copy scp license-file filename ip
where:
filename – the filename, including the full path
●
ip – the ip address of the ftp/tftp/scp server.
●
For example:
2. Optionally, use the show download license-file status command to view the
status of the download process.
3. Use the show license status command to verify that the license was installed.
4. Use the copy running-config startup-config command to save your current
configuration.
5. Reset using the reset command.
366 Administration for the Avaya G250 and Avaya G350 Media Gateways
copy tftp license-file my_license_file.xml 198.87.134.153