Configuring Object Tracking - Avaya G250 Administration

Configuring WAN interfaces
6. Optionally, use the source-address command to specify a source IP address, instead of
using the output interface's address. By default, the source-address command is
disabled, and RTR probes use the output interface's address.
Use the source-address command when you are probing a device located on the
Internet, and specify as the source-address the G250/G350 public IP address.
G350-001(config-rtr icmp 5)# source-address 135.64.102.5
Done!
7. Optionally, configure the RTR parameters that determine when the state of the remote
device is considered up and when down. If you do not configure these characteristics, their
default values are used:
Use the wait-interval command to specify how long to wait for a response from the
●
device. When the wait-interval is exceeded, the probe is considered an unanswered
probe. The default value is the current value of frequency.
Use the fail-retries command to specify how many consecutive unanswered
●
probes change the state of an RTR from up to down. The default value is 5
Note:
When an RTR starts running, its state is considered up.
Note:
Use the success-retries command to specify how many consecutive answered
●
probes change the state of an RTR from down to up. The default value is 5.
G350-001(config-rtr icmp 5)# wait-interval 2 seconds
Done!
G350-001(config-rtr icmp 5)# fail-retries 3
Done!
G350-001(config-rtr icmp 5)# success-retries 1
Done!
8. Exit the rtr-type context, and activate the RTR using the rtr-schedule command.
Note:
To deactivate the RTR, use the no rtr-schedule command.
Note:
G350-001(config-rtr icmp 5)# exit
G350-001(config)# rtr-schedule 5 start-time now life forever

Configuring object tracking

To configure object tracking, you must first configure at least one simple object tracker, that is,
an object tracker that tracks a single RTR. If you wish, you can then configure a track list which
contains multiple simple object trackers and specifies how to calculate the overall state of the
list. Note that a track list is itself an object tracker. Therefore, you can configure track lists
containing object trackers which are either simple object trackers, or other track lists.
174 Administration for the Avaya G250 and Avaya G350 Media Gateways