Initial Wan Configuration; Configuring The Avaya Mm340 E1/T1 Wan Media Module - Avaya G250 Administration

Initial WAN configuration

To configure the Avaya G250/G350 Media Gateway to support a WAN:
1. Add one of the following WAN media modules:
- Avaya MM340 E1/T1 media module
- Avaya MM342 USP media module
Note:
You can also use the Fast Ethernet port on the G250/G350 chassis as the
Note:
endpoint for a WAN line by configuring this interface for PPPoE. See
PPPoE
2. Connect the WAN line to the media module. For more information, see Installation and
Upgrades for the Avaya G250 Media Gateway, 03-300434 or Installation and Upgrades for
the Avaya G350 Media Gateway, 03-300394.
3. Configure the WAN interface on the WAN media module:
- For the MM340, see
page 133.
- For the MM342, see
page 137.
4. By default, a G250/G350 WAN interface uses Point-to-Point Protocol (PPP). For
instructions on changing the default PPP parameters, see
5. If you want frame relay encapsulation on the WAN, configure frame relay. See
frame relay
6. Test the WAN configuration. See
connectivity
7. Use the copy running-config startup-config command to save the configuration.

Configuring the Avaya MM340 E1/T1 WAN media module

For a list of G250/G350 default settings, see
current settings, use the show controllers command.
To configure an E1 or T1 port:
1. Use the show-ds command to check if the G250/G350 is configured for E1 or T1 operation.
2. Use the ds-mode command to set the mode of the G250/G350 to E1 or T1. Changing the
line type requires resetting the module. The default value is T1.
on page 139.
Configuring the Avaya MM340 E1/T1 WAN media module
Configuring the Avaya MM342 USP WAN media module
on page 143.
Verifying the WAN configuration and testing
on page 145.
Configuring PPP
E1/T1 default settings
Initial WAN configuration
Configuring
on
on
on page 139.
Configuring
on page 136. To display the
Issue 1.1 June 2005 133