Application Example - Avaya G250 Administration

In PBR list context:
●
- show list — displays all the parameters of the current PBR list
- show ip-rule — displays the parameters of all rules configured for the current list
- show ip-rule rule number — displays the parameters of the specified rule
In next hop list context:
●
- show next-hop — displays the next hop entries in the current next hop list and their
current status

Application example

The following example creates a policy-based routing scheme in which:
Voice traffic is routed over a serial interface. If the interface is down, the traffic is dropped.
●
Data traffic is routed over a GRE tunnel. If the tunnel is down, the traffic is routed over the
●
serial interface. If both interfaces are down, the traffic is dropped.
Figure 50: Sample policy-based routing application
application described below.
Figure 50: Sample policy-based routing application
This example includes a voice VLAN (6) and a data VLAN (5). The PMI is on VLAN 6. The
G250/G350 is managed by a remote Media Gateway Controller (MGC) with the IP address
149.49.43.210. The G250/G350 also includes a local S8300 in LSP mode.
IP phones are located on the same subnet as the PMI. Therefore, there is no routing between
the PMI and the IP phones.
on page 475 illustrates the sample
Issue 1.1 June 2005
Application example
475