Chapter 17: Configuring the router
This chapter provides information about configuring the G250/G350 router and contains the
following sections:
Overview of the G250 and G350 router
●
router, along with instructions for enabling and disabling the router
Configuring interfaces
●
and VLAN interfaces on the router
Configuring unnumbered IP interfaces
●
interface to borrow an IP address from another interface, rather than assigning the
interface its own IP address
Configuring the routing table
●
Configuring GRE tunneling
●
Configuring DHCP and BOOTP relay
●
BOOTP relays for routing on the G250/G350
Configuring DHCP server
●
G350
Configuring broadcast relay
●
on the G250/G350
Configuring the ARP table
●
Enabling proxy ARP
●
Configuring ICMP errors
●
ICMP error messages
Configuring RIP
●
the router
Configuring OSPF
●
on the router
Route redistribution
●
routing protocols
Configuring VRRP
●
redundancy of LAN routers and load balancing
Configuring fragmentation
●
reassembly on the G250/G350 router
— instructions on how to configure Fast Ethernet, Loopback, Serial,
— instructions on how to configure the routing table
— instructions on how to configure GRE tunnels on the router
— instructions on how to configure DHCP server on the G250/
— instructions on how to configure broadcast relay for routing
— instructions on how to configure the ARP table
— instructions on how to enable proxy ARP on an interface
— instructions on how to configure whether the router sends
— instructions on how to configure RIP parameters for each interface on
— instructions on how to configure OSPF parameters for each interface
— instructions on how to configure route redistribution among multiple
— instructions on how to configure the VRRP protocol so as to support
— instructions on how to configure IP fragmentation and
— a list of features supported on the G250/G350
— instructions on how to configure a point-to-point
— instructions on how to configure DHCP and
Issue 1.1 June 2005
311