Supported Ports For Lldp - Avaya G250 Administration

Configuring Ethernet ports
2. Configure the administrative LLDP port status using the set port lldp command
(optional). The default value is rx-and-tx.
G250-001(super)# set port lldp 10/3 rx-and-tx
Done!
The device now sends LLDP TLVs and accepts LLDP TLVs from neighboring devices
supporting LLDP on the specified port.
3. Configure additional TLVs transmission using the set port lldp tlv command
(optional). This allows you to advertise additional data about the device's and port's VLAN
information, VLANs, and system capabilities. Additional TLVs are disabled by default.
G250-001(super)# set port lldp tlv 10/3 enable all
Done!
The device now advertises all mandatory and optional TLVs to neighboring network devices
supporting LLDP.
4. Verify LLDP advertisements using the show lldp command.

Supported ports for LLDP

Only designated ports can be configured to support LLDP.
For the G250, module 10, ports 3-10. This includes all Ethernet ports on the G250 other
●
than the Ethernet WAN port connecting directly to the chassis.
For the G350, module 6, ports 1-24 and 51 (MM314 only). This includes all Ethernet ports
●
on the G350 other than the Ethernet WAN port connecting directly to the chassis.
102 Administration for the Avaya G250 and Avaya G350 Media Gateways