Chapter 10: Configuring WAN interfaces
This chapter provides information about configuring WAN features on the Avaya G250/G350
Media Gateway and contains the following sections:
WAN overview
●
Serial interface overview
●
Initial WAN configuration
●
G350
Backup interfaces
●
G350
Modem dial backup
●
how to configure it on the G250/G350
ICMP keepalive
●
through an interface at defined intervals to determine if the interface is up or down
Dynamic CAC
●
interface
Object tracking
●
interface
Frame relay encapsulation
●
supported on the G250/G350
Priority DLCI
●
configure priority DLCI on a WAN interface
WAN configuration example
●
WAN overview
You can use an MM340 E1/T1 media module or an MM342 USP media module as an endpoint
for a WAN line on both the G250 and the G350. You can also use the Fast Ethernet port on the
G250/G350 chassis as the endpoint for a WAN line by configuring the Fast Ethernet interface
for PPP over Ethernet (PPPoE). The G250/G350 serves as a router, as well as the endpoint, for
the WAN line. For more information about routing, see
The G250/G350 supports the following WAN features:
PPP over channeled and fractional E1/T1 — the G250/G350 has the ability to map several
●
PPP sessions to a single E1/T1 interface
— a description of the WAN features supported on the G250/G350
— an overview of serial interfaces
— instructions on how to configure a WAN line on the G250/
— a description of backup interfaces and how they work on the G250/
— a description of modem dial backup using the Dialer interface and
— a description of the ICMP keepalive feature for sending ping packets
— a description of dynamic CAC and how to configure it on a WAN
— a description of object tracking and how to configure it on a WAN
— a description of the frame relay encapsulation features
— a description of class-based traffic assignment (priority DLCI) and how to
— an example of a WAN configuration on the G250/G350
Configuring the router
Issue 1.1 June 2005
on page 311.
129