Rtp Statistics Cli Commands - Avaya G250 Administration

Configuring monitoring applications
Codec:
G711U 40B 0mS Off, Silence-suppression(Tx/Rx) Disabled/Disabled, Play-Time 161.9
00sec, Loss 0.0% #0, Avg-Loss 0.0%, RTT 103mS #0, Avg-RTT 105mS, JBuf-under/over
runs 0.0%/0.0%, Jbuf-Delay 11mS, Max-Jbuf-Delay 13mS
Received-RTP:
Packets 8094, Loss 0.0% #0, Avg-Loss 0.0%, RTT 8mS #0, Avg-RTT 9mS, Jitter 0mS #
0, Avg-Jitter 0mS, TTL(last/min/max) 0/64/64, Duplicates 0, Seq-Fall 0, DSCP 0,
L2Pri 6, RTCP 30
Transmitted-RTP:
VLAN 400, DSCP 46, L2Pri 6, RTCP 30
Remote-Statistics:
Loss 0.0% #0, Avg-Loss 0.0%, Jitter 1mS #0, Avg-Jitter 0mS
Echo-Cancellation:
Loss 49dB #0, Len 0mS
RSVP:
Status Reserved, Failures 0
The conference ID that appears in the Phone string for session 1 and for session 2 is identical,
which identifies the two sessions as belonging to the same conference call [1] [2].

RTP statistics CLI commands

Table 16 lists the various CLI commands related to the RTP statistics application.
Table 16: RTP statistics application CLI commands
Command
rtp-stat clear
rtp-stat event-threshold
rtp-stat fault
rtp-stat min-stat-win
rtp-stat qos-trap
rtp-stat threshold
280 Administration for the Avaya G250 and Avaya G350 Media Gateways
Description
Reset the RTP statistics application
Set a QoS event-threshold for RTP streams
Configure the RTP statistics application to send QoS fault
and/or clear traps
Set the RTP statistics minimum statistic window
Configures the RTP statistics application to automatically
send a QoS trap upon the termination of an RTP stream
in which one or more QoS event counters exceeded their
configured threshold
Sets thresholds for the RTP statistics applications
1 of 2