Device-Wide Policy Lists - Avaya G250 Administration

To remove a list from an interface, use the no form of the appropriate command. For example, if
the Ingress Access Control List for the VLAN 1 interface is list number 302, you can remove the
list from the interface by typing the following commands:
G350-001(super)# interface Vlan 1
G350-001(super-if:Vlan 1)# no ip access-group in
Done!
Note:
You cannot change or delete a default list. You cannot change or delete any list
Note:
when it is attached to an interface. In order to change or delete a list that is
attached to an interface, you must first remove the list from the interface. You can
then change or delete the list. After changing the list, you can reattach the list to
the interface.

Device-wide policy lists

You can attach a policy list (other than a policy-based routing list) to every interface on the
G250/G350 using one command. To do this, attach a list to the Loopback 1 interface. For more
information, see
Note:
If you attach a policy list to a Loopback interface other than Loopback 1, the
Note:
policy list has no effect.
When you attach a policy list to the Loopback 1 interface, thereby creating a device-wide policy
list, and you also attach policy lists to specific interfaces, the G250/G350 applies the lists in the
following order:
Incoming packets:
●
a. Apply the ingress policy lists that are attached to the interface.
b. Apply the device-wide ingress policy lists.
Outgoing packets:
●
a. Apply the device-wide egress policy lists.
b. Apply the egress policy lists that are attached to the interface.
Attaching policy lists to an interface
Device-wide policy lists
on page 447.
Issue 1.1 June 2005 449