Configuring the G250 and G350 for modem use
Use the ip address command to assign an IP address to the USB port. This is the IP
●
address to which a remote user can connect using telnet. For example, to assign the IP
address 192.168.22.33 to the USB port, use the following command:
G350-001(if:USB)# ip address 192.168.22.33
There is no default IP address for the USB port.
Use the ppp authentication command to configure the authentication method used
●
when starting a client session on the PPP server. Use this command with one of the
following parameters:
- pap — Password Authentication Protocol. An unencrypted password is sent for
authentication.
- chap — Challenge Handshake Authentication Protocol. An encrypted password is sent
for authentication. To configure this password, use the ppp chap-secret command.
- ras — reserved for future use
- none — no password is sent
Note:
The ppp authentication command changes the PPP authentication
Note:
parameters of the console port as well as the USB port, even if you use the
command in USB interface context.
Use the shutdown command to disconnect a session.
●
Use the timeout absolute command to set the number of minutes until the system
●
automatically disconnects an idle PPP incoming session. By default, there is no timeout.
Use the ip peer address command to change the IP address offered to a requesting
●
calling host during PPP/IPCP connection establishment. By default, the interface offers its
own IP address plus one.
Use the show interface usb-modem command to display the USB interface
●
parameters, the current status of the USB port, and the identity of any USB modem
connected to the USB port.
126 Administration for the Avaya G250 and Avaya G350 Media Gateways