Avaya G250 Administration page 89

Example 2 creates a dtmf, loop-start trunk group 33 with 1 member that requires that the
user dial "#33" for access:
● set trunk-group 33 dtmf #33 loop-start
add trunk-group 33 v303
●
Example 3 creates a dtmf, loop-start trunk group 34 with 1 member that requires that the
user dial "#34" for access:
set trunk-group 34 dtmf #34 loop-start
●
add trunk-group 34 v304
●
5. Type the set dial-pattern dialed-string length type deny tgnum command
for each SLS dial pattern.
!
Important:
The trunk group must already exist (see Step 4 above) before you can use this
Important:
command.
Examples
set dial-pattern 100 4 fnpa false 30
●
set dial-pattern 200 4 fnpa false 30
●
6. Type the set ars-fac fac command to set the Feature Access Code. For example:
● set ars-fac *9
set ars-fac 8
●
7. Type the set-ip-codec-set command to select the country-specific G.711 codec
(G.711mu or G.711a).
8. To change the maximum allowable IP registrations from the default (8), use the set
max-ip-registrations n command, where n is between 1-10.
!
Important:
Since the VOIP resources on the G250 are limited, adjusting the maximum IP
Important:
registrations above the default value (8) can result in system performance
problems.
9. Type the exit command to leave the survivable-call-engine context.
10. Type the copy running-config startup-config command to save the configuration
changes.
11. Type the set survivable-call-engine enable command to enable SLS on the
G250 media gateway.
Configuring SLS
Issue 1.1 June 2005 89