Avaya G250 Administration page 135

6. Type exit to return to general context. The prompt returns to:
G350-001(super)#
7. Use the interface Serial command to enter the context of the interface. Specify the
slot number of the media module, the port number, the channel group number, and
optionally, the IP interface number.
Note:
The WAN media module in a G250 must always be in slot number 2. The G250
Note:
only supports a single channel group.
If you do not specify an IP interface number for the first serial interface that you define on a
channel group, the G250/G350 automatically assigns IP interface number 0. For each
additional serial interface that you define on the channel group, use a different IP interface
number. For example:
- interface Serial 2/1:1 enters a serial interface on the media module in slot
number 2, on port number 1, with channel group number 1.
- interface Serial 5/1:2.3 enters a serial interface on the media module in slot
number 5, on port number 1, with channel group number 2, and with IP interface
number 3.
Note:
If you use the framing unframed command in Step 3 for an E1 port, a channel
Note:
group is automatically created on the entire E1 bandwidth. The channel group
has the number 0. In Step 6, use the command interface Serial s/p:0
where s is the slot number and p is the port number.
Note:
After the serial interface is created, its default encapsulation is PPP.
Note:
8. Configure the interface encapsulation:
- By default, the serial interface uses PPP encapsulation. For information on setting PPP
parameters, or instructions on returning the interface to the default PPP encapsulation
after it has been configured for a different encapsulation, see
page 139.
- For frame relay encapsulation, see
9. Use the ip address command to configure the IP address and subnet mask of the
interface.
10. Type exit to return to general context. The prompt returns to:
G350-001(super)#
11. If needed, repeat Step 7 through Step 9 to configure additional IP interfaces on the same
channel group.
Configuring frame relay
Initial WAN configuration
Configuring PPP on
on page 143.
Issue 1.1 June 2005 135