Avaya G250 Administration page 517

22. In the G250 only: disable the SLS, using the set survivable-call-engine disable
command.
Note:
This command does not apply to the G350 or G250-BRI.
Note:
G250-001(super)# set survivable-call-engine disable
Survivable Call Engine is disabled
23. Configure other module configuration-related parameters, such as: VoIP, Media, L2
switching, E1/T1.
24. Determine which interfaces will be used for clear-text data, and which for encrypted data.
Note that private interfaces such as Vlans should be clear, while public interfaces such as
FastEthernet 10/2 and Serial X/Y should be encrypted.
25. Configure additional interfaces, including the interfaces' IP addresses.
G350-N(super)# interface fastethernet 10/2
G350-N(super-if:FastEthernet 10/2)# ip address 10.0.0.1 255.255.255.0
Done!
G350-N(super)# interface serial 2/1:1
G350-N(super-if:serial 2/1:1)# encapsulation ppp
Done!
G350-N(super-if:serial 2/1:1)# ip address 1.0.0.1 255.255.255.252
Done!
G350-N(super-if:serial 2/1:1)# exit
G350-N(super)#
26. Remove all unnecessary users, as follows:
a. Use the show username command to list CLI users.
G350-N(super)# show username
User
account
--------------------------------
root
b. If there are redundant CLI users, use the no username command to delete them.
Note that you cannot delete the root user.
c. Use the show snmp user command to list SNMPv3 users.
G350-N(super)# show snmp user
EngineId: 80:00:1a:e9:03:00:04:0d:29:ca:61
User Name: initial
Authentication Protocol: none
Privacy Protocol: none
Storage Type: nonVolatile
Row Status: active
Access Account
level type
----------- ----------
admin local
(local)
Administration procedures
Active Authent.
method
------ ----------
yes password
Issue 1.1 June 2005 517