In QoS list rule context:
●
- show composite-operation — displays the parameters of the composite operation
assigned to the current rule
- show dscp-table — displays the current list's DSCP table
- show ip-rule — displays the parameters of the current rule
In QoS list DSCP table context:
●
- show dscp-table — displays the parameters of the current DSCP table entry
In QoS list composite operation context:
●
- show composite-operation — displays the parameters of the current composite
operation
Simulating packets
Use the ip simulate command in the context of an interface to test a policy list. The
command tests the effect of the policy list on a simulated IP packet in the interface. You must
specify the number of a policy list, the direction of the packet (in or out), and a source and
destination IP address. You may also specify other parameters. For a full list of parameters, see
Avaya G250 and Avaya G350 CLI Reference, 03-300437.
The following command simulates the effect of applying QoS list number 401 to a packet
entering the G350 through interface VLAN 2:
G350-001(if:Vlan 2)# ip simulate 401 in CoS1 dscp46 10.1.1.1
10.2.2.2 tcp 1182 20
The simulated packet has the following properties:
CoS priority is 1
●
DSCP is 46
●
source IP address is 10.1.1.1.
●
destination IP address is 10.2.2.2.
●
IP protocol is TCP
●
source TCP port is 1182
●
destination TCP port is 20
●
Displaying and testing policy lists
Issue 1.1 June 2005
463