Spanning Tree Cli Commands - Avaya G250 Administration

For example, the following command specifies that ports 3 to 5 on module 5 are treated is if
they were connected point-to-point:
G350-001(super)# set port point-to-point admin status 5/3-5 force-true
Use the show port point-to-point status command, followed by the module and
port number, to display the point-to-point status of the specified point-to-point status of all
ports.

Spanning tree CLI commands

Use the following commands to configure spanning tree. For more information about these
commands, see Avaya G250 and Avaya G350 CLI Reference, 03-300437.
Use the set port spantree command to enable or disable the spanning tree mode for
●
specific switch ports.
Use the set spantree default-path-cost command to set the version of the
●
spanning tree default path cost used by this bridge.
Use the set spantree enable/disable command to enable or disable the spanning
●
tree algorithm.
Use the set spantree forward-delay command to specify the time used when
●
transferring the state of a port to the forwarding state.
Use the set spantree hello-time command to specify the time interval between the
●
generation of configuration BPDUs by the root.
Use the set spantree max-age command to specify the time to keep an information
●
message before it is discarded.
Use the set spantree priority command to set the bridge priority for STP.
●
Use the set spantree tx-hold-count command to set the value in packets used by
●
the spanning tree in order to limit the maximum number of BPDUs transmitted during a
hello-time period.
Use the set spantree version command to set the version of the spanning tree
●
protocol.
Use the show spantree command to display spanning-tree information.
●
Configuring spanning tree (G350 only)
Issue 1.1 June 2005 235