Switch Ethernet Port Commands - Avaya G250 Administration

Switch Ethernet port commands

Use the following commands for basic configuration of switch Ethernet ports. For more
information about these commands, see Avaya G250 and Avaya G350 CLI Reference,
03-300437.
Use the set port auto-negotiation-flowcontrol-advertisement command
●
to set the flowcontrol advertisement for the specified port when performing
auto-negotiation. This command is only applicable to the Gigabit Ethernet port.
Use the set port disable command to disable a port or range of ports.
●
Use the set port duplex command to configure the duplex type of an Ethernet or Fast
●
Ethernet port or range of ports.You can configure Ethernet and Fast Ethernet interfaces to
either full duplex or half duplex. The duplex status of a port in auto-negotiation mode is
determined by auto-negotiation. When auto-negotiation is enabled, an error message is
generated if you attempt to set the transmission type of auto-negotiation Fast Ethernet
ports to half-duplex or full-duplex mode.
Use the set port edge admin state command to set the administrative state the
●
specified port is assumed to be in.
Note:
This command is not supported by the G250.
Note:
Use the set port enable command to enable a port or a range of ports.
●
Use the set port level command to determine the default packet priority level for
●
untagged packets. Packets traveling through a port set at normal priority should be served
only after packets traveling through a port set at high priority are served.
Use the set port name command to configure a name for a port.
●
Use the set port negotiation command to enable or disable the link negotiation
●
protocol on the specified port. This command applies to Fast Ethernet or Gigabit Ethernet
ports. When negotiation is enabled, the speed and duplex of the Fast Ethernet ports are
determined by auto-negotiation. If negotiation is disabled, the user can set the speed and
duplex of the Fast Ethernet ports.
Use the set port point-to-point admin status command, followed by the
●
module and port number of the port, to manage the connection type of the port. Use one of
the following arguments with this command:
- force-true — the port is treated as if it were connected point-to-point
- force-false — the port is treated as if it were connected to shared media
- auto — the G350 tries to automatically detect the connection type of the port
Note:
This command is not supported by the G250.
Note:
Configuring switch Ethernet ports
Issue 1.1 June 2005 93