Configuration Example For Site B - Avaya G250 Administration

Configuration Example for Site B

The following is the procedure for configuring PPP VoIP on the G350 at Site B.
Loopback and PMI interfaces configuration:
●
G350-001# interface Loopback 1
G350-001(if:Loopback1)# ip address 4.4.4.11 32
Done!
G350-001(if:Loopback 1)# pmi
The Primary management interface has changed. Please copy the running configuration
to the start-up configuration file, and reset the device.
G350-001(if:Loopback1)# exit
G350-001# copy running-config startup-config
G350-001# reset
VLAN interface configuration:
●
G350-001# interface Vlan 1
G350-001(if:Vlan 1)# ip address 3.3.3.1 24
G350-001(if:Vlan 1)# exit
G350-001# interface Vlan 2
G350-001(if:Vlan 1:2)# ip address 33.33.33.1 24
G350-001(if:Vlan 1:2)# exit
Serial interface configuration:
●
G350-001# controller t1 5/1
G350-001(controller:5/1)# channel-group 1 timeslots 1-2 speed 64
G350-001(controller:5/1)# exit
G350-001# interface Serial 5/1:1
G350-001(if:Serial 5/1:1)# ip address 2.2.2.2 24
G350-001(if:Serial 5/1:1)# mtu 300
Note:
Some LAN data applications do not support fragmented packets. In this case, do
Note:
not change the MTU from its default of 1500.
VoIP configuration:
●
G350-001(if:Serial 5/1:1)# ip rtp header-compression
G350-001(if:Serial 5/1:1)# ip rtp compression-connections 20
G350-001(if:Serial 5/1:1)# ip rtp port-range 2048 3028
G350-001(if:Serial 5/1:1)# exit
Static routes configuration:
●
G350-001# ip route 1.1.1.0 24 serial 5/1:1
G350-001# ip route 11.11.11.0 24 serial 5/1:1
WAN configuration example
Issue 1.1 June 2005 191