Configuring Frame Relay - Avaya G250 Administration

6. If the G250/G350 is connected to the Internet via the Fast Ethernet interface configured for
PPPoE, and you define a VPN tunnel which specifies remote hosts by name, it is
recommended to use the ppp ipcp dns request command. This command requests
the list of available DNS servers from the remote peer during the PPP/IPCP session. The
DNS servers are used by the DNS Resolver to resolve host names to IP addresses (see
DNS Resolver
7. Type exit to return to general context. The prompt returns to:
G350-001(super)#
8. Test the configuration. See
page 145.
9. Use the copy running-config startup-config command to save the configuration.
To shut down the port, and the PPPoE client (if configured), use the shutdown command in the
interface context.

Configuring frame relay

To configure frame relay encapsulation on a WAN port:
1. Ensure that the port is configured on the media module:
- For an E1/T1 port, see
page 133.
- For a USP port, see
page 137.
2. Ensure that you are in the context of a serial interface that is defined on the port. If you are
not in the context of a serial interface, use the interface Serial command. To view all
serial interfaces that are defined, use the show interfaces Serial command.
3. Use the encapsulation frame-relay command to change the encapsulation to
frame relay.
4. If needed, use the frame-relay lmi commands to change the Local Management
Interface (LMI) parameters from their default values, or use the frame-relay
traffic-shaping command to activate traffic shaping on the frame relay interface. For
more information on traffic shaping, see
5. If you want to change the queuing mode of the interface, see
VoIP Queuing (WFVQ)
6. Type exit to return to general context. The prompt returns to:
G350-001(super)#
on page 65).
Verifying the WAN configuration and testing connectivity
Configuring the Avaya MM340 E1/T1 WAN media module
Configuring the Avaya MM342 USP WAN media module
on page 124 for instructions.
Traffic Shaping and Marking
Configuring Weighted Fair
Initial WAN configuration
on
on
on
on page 186.
Issue 1.1 June 2005 143