Avaya DEFINITY Server CSI Maintenance Manual page 1894

Maintenance Objects
Table 568. TEST #1105 VC-DSP Port DSP Loopback Test
Error Test
Code Result
1000 ABORT
1002 ABORT
1003 ABORT
1004 ABORT
2000 ABORT
2012 ABORT
2100 ABORT
0, 1 FAIL
PASS
1894
Issue 5 October 2002
Description/Recommendation
System resources required to run this test are not available, or the port is
busy with a valid call.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The system could not allocate time slots for the test, the traffic load on the
system is very high, or time slots are out-of-service due to TDM-BUS errors.
Refer to ''TDM-BUS (TDM Bus)''
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
repeat the test at 1-minute intervals a maximum of 5 times.
The system could not allocate a Tone Detector for the test, the system is
oversized for the number of Tone Detectors present, or some Tone
Detectors are out-of-service.
1. Resolve any ''TTR-LEV (TTR Level)''
2. Resolve any ''TONE-PT (Tone Generator)''
3. If neither condition exists, retry the test at 1-minute intervals a maximum
of 5 times.
The port has been seized by a user for a valid call. Use the status station
command for the station associated with this port and determine if the port is
available for testing
1. Retry the command at 1-minute intervals a maximum of 5 times.
Response to the test request was not received from the VC-BD circuit pack
within the allowable time period.
1. If this result occurs repeatedly, reset the circuit pack if the other ports are
not in use by using the busyout port PCSSpp and reset port PCSSpp
commands.
2. If this result occurs again, replace the circuit pack.
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
Could not allocate the necessary system resources to run this test.
1. Rerun the test at 1-minute intervals a maximum of 5 times.
The VC-DSPPT DSP Loopback Test failed.
1. Replace the circuit pack.
The VC DSPPT DSP Loopback Test passed
to diagnose TDM Bus errors.
errors.
errors.
Continued on next page