Configure Stpd Tag - Extreme Networks ExtremeWare Command Reference Manual

STP Commands

configure stpd tag

configure stpd <spanning tree name> tag <vlan tag>
Description
Assigns an StpdID to an STPD.
Syntax Description
spanning tree name
vlan tag
Default
N/A.
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
An StpdID is used to identify each STP domain. You assign the StpdID when configuring the domain.
An StpdID must be identical to the VLANid of one of the member VLANs in that STP domain, and that
VLAN cannot belong to another STPD. Unless all ports are running in 802.1d mode, an STPD must be
configured with an StpdID.
You must create and configure the VLAN, along with the tag, before you can configure the STPD tag. To
create a VLAN, use the
create vlan
command.
In addition to the VLAN attributes that you will use in the STPD, you must first create an STPD. To
create an STPD, use the
create stpd
Example
The following command assigns an StpdID to the
configure stpd purple_st tag 200
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
1020
Specifies an STPD name on the switch.
Specifies the VLANid of a VLAN that is owned by the STPD.
command. To configure the VLAN, use the
command.
purple_st
configure vlan
STPD:
ExtremeWare Software 7.3.0 Command Reference Guide