Disable Multinetting - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

IP Unicast Commands

disable multinetting

disable multinetting {proprietary | standard}

Disables multinetting in the switch.

Syntax Description

If neither keyword is used, then proprietary multinetting is disabled by default.

Usage Guidelines

This command disables proprietary multinetting or standard multinetting in the switch.

Standard multinetting cannot be disabled if there are secondary IP addresses configured in the switch.

Use the following command to enable multinetting:

enable multinetting

The following command disables standard multinetting in the switch:

disable multinetting standard

This command was first available in ExtremeWare 2.0.

The proprietary and standard options were made available for this command in ExtremeWare 7.3.0.

Platform Availability

This command is available on all platforms.

Specifies that proprietary multinetting is to be disabled. The proprietary

keyword indicates that multinetting operation is done by creating VLANs with

dummy protocols and associating IP addresses with them. Proprietary

multinetting is the default value.

Specifies that standard multinetting is to be disabled. The standard keyword

indicates that multinetting operation is done by associating multiple IP subnets

with a single VLAN without using dummy-protocol based VLANs.

ExtremeWare Software 7.3.0 Command Reference Guide

Extremeware 7.3.0