Configure Rip Vlan Export-Filter - Extreme Networks ExtremeWare Command Reference Manual

IGP Commands

configure rip vlan export-filter

configure rip vlan [<vlan name> | all] export-filter [<access profile> |
none]
Description
Configures RIP to suppress certain routes when performing route advertisements.
Syntax Description
vlan name
all
access profile
none
Default
N/A.
Usage Guidelines
Use an access profile to determine trusted RIP router neighbors for the VLAN on the switch running
RIP.
Using the none mode, the access profile can contain a combination of permit and deny entries. Each
entry must have a permit or deny attribute. The operation is compared with each entry in the list. When
a match is found, the operation is either permitted or denied, depending on the configuration of the
matched entry. If no match is found, the operation is implicitly denied.
Example
The following command uses the access profile nosales to determine which RIP routes are advertised
into the VLAN backbone:
configure rip vlan backbone export-filter nosales
History
This command was first available in ExtremeWare 4.0.
Platform Availability
This command is available on all platforms.
1324
Specifies a VLAN name.
Specifies all VLANs.
Specifies an access-profile name.
Specifies to check the access profile for permit and deny attributes.
ExtremeWare Software 7.3.0 Command Reference Guide