Enable Icmp Timestamp - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:
Table of Contents

Advertisement

IP Unicast Commands

enable icmp timestamp

enable icmp timestamp {vlan <vlan name>}
Description
Enables the generation of an ICMP timestamp response on one or all VLANs.
Syntax Description
vlan name
Specifies a VLAN name.
Default
Enabled.
Usage Guidelines
Enables the generation of an ICMP timestamp response (type 14, code 0) when an ICMP timestamp
request is received. If a VLAN is not specified, the command applies to all IP interfaces.
This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually
forwarded by the switch is controlled by the access-list commands.
Example
The following command enables the generation of an ICMP timestamp response on VLAN accounting:
enable icmp timestamp vlan accounting
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
1218
ExtremeWare Software 7.3.0 Command Reference Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Extremeware 7.3.0

Table of Contents