Configure Bgp Neighbor Soft-Reset - Extreme Networks ExtremeWare Command Reference Manual

configure bgp neighbor soft-reset

configure bgp neighbor [<ip address> | all] soft-reset {in | out}
Description
Applies the current input or output routing policy to the routing information already exchanged with
the neighbor.
Syntax Description
ip address
all
in
out
Default
N/A.
Usage Guidelines
The input/output policy is determined by the NLRI-filter, AS-path-filter, and the route map configured
for the neighbor on the input and/or output side of the router. This command does not affect the switch
configuration.
Example
The following command applies the current input routing policy to the routing information already
exchanged with the neighbor:
configure bgp neighbor 192.168.1.5 soft-reset in
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies an IP address
Specifies all neighbors.
Specifies to apply the input routing policy.
Specifies to apply the output routing policy.
configure bgp neighbor soft-reset
1423