Configure Elrp-Client Periodic - Extreme Networks ExtremeWare Command Reference Manual

ESRP Commands

configure elrp-client periodic

configure elrp-client periodic <vlan name> timeout <interval> ports
<port-mask> action [log | trap | log-and-trap]
Description
Starts periodic Extreme Loop Recovery Protocol (ELRP) packet transmission on the specified ports of
the VLAN using the specified interval.
Syntax Description
vlan name
timeout <interval>
ports <port-mask>
action log
action trap
action log-and-trap
Default
None.
Usage Guidelines
This command starts periodic ELRP packet transmission on the specified ports of the VLAN using the
specified interval. If any of these transmitted packets is returned, indicating loopback detection, the
ELRP client can perform a configured action such as logging a message in the system log file and/or
sending a trap to the SNMP manager.
Use the
configure elrp-client one-shot
transmission of ELRP packets.
The ELRP client must be enabled globally in order for it to work on any VLANs. Use the
command to globally enable the ELRP client.
elrp-client
The ELRP client can be disabled globally so that none of the ELRP VLAN configurations take effect. Use
the
disable elrp-client
Example
(Need example.)
configure elrp-client periodic...
1054
Specifies a VLAN name.
Specifies the interval (in seconds) between consecutive packet transmissions.
Specifies the set of VLAN ports for packet transmission.
Specifies that a message should be logged in the system log file when ELRP
packets are received back indicating detection of network loop, or no packets
are received within the specified duration.
Specifies that a trap message should be sent to the SNMP manager when
ELRP packets are received back indicating detection of network loop, or no
packets are received within the specified duration.
Specifies that a message should be logged in the system log file and a trap
message should be sent to the SNMP manager when ELRP packets are
received back indicating detection of network loop, or no packets are received
within the specified duration.
command to configure non-periodic, one-time
command to globally disable the ELRP client.
enable
ExtremeWare Software 7.3.0 Command Reference Guide