Configure Stpd Ports Mode - Extreme Networks ExtremeWare Command Reference Manual

STP Commands

configure stpd ports mode

configure stpd <spanning tree name> ports mode [dot1d | emistp | pvst-plus]
<portlist>
Description
Configures the STP mode of operation for the specified port list.
Syntax Description
spanning tree name
dot1d
emistp
pvst-plus
portlist
Default
Ports in the default STPD (s0) are
Usage Guidelines
None.
Example
The following command configures STPD s1 with PVST+ packet formatting for port 1 on a stand-alone
switch:
configure stpd s1 ports mode pvst-plus 1
The following command configures STPD s1 with PVST+ packet formatting for slot 2, port 1 on a
modular switch:
configure stpd s1 ports mode pvst-plus 2:1
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
1016
Specifies an STPD name on the switch.
Specifies IEEE 802.1d-compliant packet formatting. A physical port can only
be a member of one STPD running it dot1d mode.
Specifies 802.1d formatting and 802.1q tagging.
Specifies PVST+ packet formatting.
Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
mode. Ports in user-created STPDs are in
dot1d
mode.
emistp
ExtremeWare Software 7.3.0 Command Reference Guide